about us

The commercial representation Marcus Plischkowsky concerns itself primarily with the selling of physical water treatment.

Due to that ever more largely becoming problem of the pollution of the drinking water by bacteria, for example Legionella, we have extended our offer by chlorine dioxide production and proportioning plants.

The Newtec Water Systems NV has toked over the products from the company ECS GmbH (an electronics firm, which specialized on the development, manufacturing and project engineering of inductive treatment devices and systems for liquid media. Due to the experience of many years optimal solutions can be offered for almost any application.

The CALC TECH water treatment device creates alternating electromagnetic fields in the water that impede the growth of lime crystals. These microfine crystals are unable to adhere and are rinsed away with the water.

CALC TECH permanently changes the impulses such that optimum results are achieved even with slowly flowing water.

The effectiveness of CALC TECH has been tested and certified by the official national institute of Austria (ÖVGW) based on the test guideline W 35.

Effectiveness proves to be greater than 90 %.

Areas of application

CALC TECH is used everywhere where lime problems arise, including:

Apartment buildings
Car wash systems with and without reverse osmosis
Industrial applications
Refregeration plants
Community systems
... and much more, please ask us - we are sure we find a solution

CALC TECH is currently being used at about 30.000 locations worldwide.

What are the advantages of the CALC TECH electronic inductive water treatment device ?

Significantly reduces energy loss at the heat exchanger
(a 6,5 mm lime layer creates a loss of energy of around 40 %)
No more lime encrusted boilers
No more lime encrusted piping systems
No lime encrusted mixers and fittings
Increased life cycles for such devices as washing machines and dish washing machines
Affordable installation without cutting into the piping system
No maintenance costs, no additional costs, minimal running costs
CALC TECH does not affect water quality
Important minerals and trace elements remain
Water hardness is unaffected
Environmentally friendly, since CALC TECH works without chemicals
Requires little space
Can be used with every piping system
Can be set to specific values of water hardness and water usage
Works independent of flow rate and direction

Water treatment

There are two kinds of water treatment

Chemical treatment
Physical treatment

Physical treatment

In contrast to chemical treatment, with physical treatment the water is not softened, no minerals are extracted, and no chemicals are added. The quality and hardness of the water are unaffected.

For untreated water, lime crystals are large in size (approx. 150 µm) and have a needle-like structure. This structure gives the crystals a very high degree of adhesion.

Lime crystals that form after physical treatment have a maximum size of 20 µm and no longer possess a needle-like structure. They are unable to adhere to each other and therefore no longer stick to the surfaces of pipes, heating rods, etc. The microfine lime crystals remain in the water as a valuable element and are carried out with the effluent.

Existing sediments with their porous surfaces and fine cracks can no longer accumulate more deposited materials. As water flows by, cracks increase and the lime layer loses its adhesive capacity. Vibrations and thermal fluctuations help to slowly loosen the layer of lime, allowing it to be carried off with the water.

Practically, this means that during the initial phases, loose lime deposits can collect at the outlet. These particles must be removed in irregular intervals.

All physical processes are characterized by the fact that the water state that is created is unstable. If the device is turned off, calcium carbonate accumulation resumes after two to three days.